Installation; Electrical Requirements; Adjusting The Feet - Candy GrandO GO DC 68G Manuel D'utilisation

40005612Eng.qxd 07/07/2008

Installation

You may be
charged for a
service call if a
problem with
your machine is
caused by
incorrect
installation.
If the mains cord
on this
appliance is
damaged, it
must be
replaced by a
special cord
which is ONLY
obtainable from
the spares
service. It must
be installed by a
competent
person.
6
16:14 Page 6

Electrical requirements

Tumble dryers are supplied to operate at a
voltage of 230V, 50 Hz single phase. Check that
the supply circuit is rated to at least 10A.
Electricity can be extremely dangerous.
This appliance must be earthed.
The socket outlet and the plug on the appliance
must be of the same type.
Do not use multiple adapters and/or extension
leads.
The plug should be accessible for disconnection
after the appliance has been installed.
The wires in the mains lead are coloured in
accordance with the following codes:
Blue
Brown
Green and Yellow
CE Appliance complies with European Directive
89/336/EEC, 73/23/EEC and subsequent amendments.
Do not plug the machine in and
switch it on at the mains until the
installation is completed.
For your safety, this dryer must be
correctly installed.
If there is any doubt about
installation, call GIAS Service for

Adjusting the feet

Once the machine is in place the feet should be
adjusted to ensure that the machine is level.
NEUTRAL
LIVE
EARTH
advice.