Philips AC4012 Mode D'emploi page 17

4
Remove all packaging material from the
new ilters.
5
Place the new HEPA ilter in the puriier
irst.
6
Then, place the new activated carbon
ilter in the puriier.
7
Place the pre-iler in the puriier.
Note
•
Make sure that the side with the two
projections is pointing towards you, and that all
hooks of the pre-ilter are properly attached
to the puriier.
8
To reattach the front panel, insert the top
hooks into the top of the puriier irst (1).
Then, push the panel against the body of
the puriier (2).
1
9
Reset the activated carbon ilter and the
HEPA ilter lifetime (see 'Reset the ilter
lifetime counter').
2
EN 17