Télécharger Imprimer la page

LENCO Xemio-154 Mode D'emploi page 4

Masquer les pouces Voir aussi pour Xemio-154:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

SRO1059 / 1061 / 1062
B. Insert Micro SD Memory Card (not included)
This device is design without an internal memory; before you use it,
insert a Micro SD memory card into player.
1. Turn "Off" the play;
2. Open the silicon cover and then insert the memory card into the
player's memory card slot; make sure the memory card is firmly and
correctly inserted. Then close the silicon cover back to position.
3. Now you can use the player for upload/download the desired media
files with your PC computer.
4. Or, Upload the desired media files direct to the Micro SD memory
card direct with your computer before insert it into player.
5. However, the device will turn to OFF automatically in few seconds if
Micro SD card not in place or not in proper position.
Note: Make sure the player power is in "Off" status when insert/remove
the Micro SD memory card from memory card slot. Otherwise, the player
functional may result dead halt or the internal data/files will be
lost/damaged.
C. About player's battery
The Player has an internal, non-user-replaceable rechargeable lithium
battery. For best results, the first time you use the player, let it charge for
about 2 ~ 3 hours or until the charging LED shows a constant red light.
Important: The player may continue to use battery power after it's been
turned to standby off mode, if the unit isn't used for a while it will need to
be recharged. For longevity of the lithium battery life, we recommended
to recharge the battery at least once per month.
D. Charging Mode
You can recharge the Player's battery in two ways:
1. Connect the player to your computer. Or,
2. Use a USB power wall charger. (not included)
3. The Status LED will blink
connected.
4. When the battery is fully charged, the Status LED will switch to a
constant
red
E. PC Connection Mode
1. Connect the player to a computer
1.1 Connect the player to a Windows OS computer with the USB
cable, then "USB Mass Storage Device" is detected and the
related driver is installed by your computer. A removable disk
drive will display in the "My computer" folder where the user can
operate Read and Write functions. And the battery will charge in
red
light.
when the USB power source is
4

Publicité

loading