Using Wi-Fi Protected Setup; Wi-Fi Protected Setup Light Activity; Connecting The Range Extender To An Existing Access Point Or Router - Linksys N300 PRO Mode D'emploi

Using Wi-Fi Protected Setup™

Wi-Fi Protected Setup makes it easy to connect your extender to your network, and
connect other devices to your network through the extender.

Wi-Fi Protected Setup light activity

Connecting the range extender to an existing access point
or router
If your access point or router supports it, you can use Wi-Fi Protected Setup to connect
the range extender to the access point or router. Log in to the settings interface and
click on WPS in the left navigation bar. Choose from the setup methods below to
connect the extender. You will have to perform the method twice to connect to the 2.4
GHz band and the 5 GHz band of your network. The 2.4 GHz band is connected first by
default.
NOTE If you have an access point or router that does not support Wi-Fi Protected Setup, note the
wireless settings and manually configure the range extender.
I Light Description
Blinking slowly WPS connection in progress.
(up to two minutes)
Solid WPS connection was
(10 seconds) successful.
Blinking quickly WPS cannot establish
(up to two minutes) connection or encounters a
problem.
Fix: Wait a few seconds after
LED stops blinking and try
again.
12