Alpine SEC-100S Mode D'emploi page 2

Introduction
English
Congratulations on your purchase of the Alpine SEC-100S/150R Mobile Security
System. The SEC-100S/150R incorporates the latest in Alpine technology and
design.
Please read this manual carefully before using your SEC-100S/150R Mobile
Security System. The SEC-100S/150R consists of two major components: a remote
control transmitter and a main unit.
The modern four-button remote control transmitter (part number SEC-RC001)
allows you to turn your system on and off from outside the vehicle while
simultaneously locking and unlocking the doors. In addition, certain functions, such
as an electronic trunk release, can be activated from the remote location. The
remote control transmitter offers the ultimate in security and convenience.
The main unit, usually mounted under the seat or under the dash, is the "brain" of
the system. It interfaces directly with different sensors and components in your
vehicle to provide optimum security and convenience.
NOTE:
Door locks and trunk release may be optional. Consult your Alpine dealer for more
information.
Proper wire connections and component placement are essential for
optimum system performance. Due to the expertise and time required to
properly install an Alpine Mobile Security System, it is highly recommended
that the installation be performed by an authorized Alpine dealer.
These devices comply with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) These devices may not cause harmful
interference, and (2) these devices must accept any interference received,
including interference that may cause undesired operation.
2