Philips QC5365 Manuel D'utilisation page 7

1 Slide the comb straight into the guiding grooves on both sides
of the handle ('click').
2 To set the comb to the desired setting, press the setting selector (1)
and slide the comb to the desired hair length setting (2).
The settings in the window show the selected hair length in
,
millimetres after cutting.
Tip: Write down the hair length settings you selected to create a certain
hairstyle as a reminder for future clipping sessions.
3 Slide the on/off slide upwards to switch on the appliance.
4 Move the appliance through the hair slowly.
tips
To clip most effectively, move the appliance against the hair growth
-
direction.
Since all hair does not grow in the same direction, you need to move
-
the appliance in different directions (upwards, downwards and across).
Make sure that the lat part of the comb is always fully in contact with
-
the scalp to obtain an even result.
- Make overlapping passes over the head to ensure that you cut all the
hair that needs to be cut.
5 Regularly remove cut hair from the comb.
If a lot of hair has accumulated in the comb, remove the comb from the
appliance and blow and/or shake the hair out of it.
Contouring without comb
You can use the appliance without comb to clip hair very close to the skin
(0.5mm) or to contour the neckline and the area around the ears.
Be careful when you clip without comb because the cutting
element removes every hair it touches.
1 Press the setting selector and slide the comb up, then pull the
comb off the appliance.
2 Before you start to contour the hairline around the ears,
comb the hair ends over the ears.
English
7