Toa D-2000 Série Manuel De L'utilisateur page 5

CAUTION
[D-2008SP, D-2012C only]
• Never plug in nor remove the power supply plug with wet hands, as doing so may cause electric shock.
• When unplugging the power supply cord, be sure to grasp the power supply plug; never pull on the cord
itself. Operating the unit with a damaged power supply cord may cause a fire or electric shock.
• When moving the unit, be sure to remove its power supply cord from the wall outlet. Moving the unit with the
power cord connected to the outlet may cause damage to the power cord, resulting in fire or electric shock.
When removing the power cord, be sure to hold its plug to pull.
• Do not block the ventilation slots in the unit cover. Besides, do not block the fan vent on the unit's rear in the
case of D-2008SP. Doing so may cause heat to build up inside the unit and result in fire. Also, periodically
clean the ventilation slots of dust.
• Avoid installing the unit in humid or dusty locations, in locations exposed to the direct sunlight, near the
heaters, or in locations generating sooty smoke or steam as doing otherwise may result in fire or electric
shock.
• Be sure to follow the instructions below when rack-mounting the unit. Failure to do so may cause a fire or
personal injury.
· Install the equipment rack on a stable, hard floor. Fix it with anchor bolts or take other arrangements to
prevent it from falling down.
· When connecting the unit's power cord to an AC outlet, use the AC outlet with current capacity allowable to
the unit.
(When rack mounting screws are supplied)
· The supplied rack-mounting screws can be used for the TOA equipment rack only. Do not use them for other
racks.
· When installing the unit in a rack other than that of TOA, be sure to use the screws with a diameter of over
5 mm (0.2") and length of over 12 mm (0.47") to mount the unit.
(When rack mounting screws are not supplied)
· Be sure to use the screws with a diameter of over 5 mm (0.2") and length of over 12 mm (0.47") to mount the
unit.
• Switch off the power, and unplug the power supply plug from the AC outlet for safety purposes when
cleaning or leaving the unit unused for 10 days or more. Doing otherwise may cause a fire or electric shock.
[D-2008SP only]
• Never touch the terminal pins on the D-2000CB when installing the D-2000CB CobraNet Interface Module
inside the D-2008SP to prevent finger injury.
[D-2012AS only]
• Avoid touching the unit's sharp metal edge to prevent injury.
The lighting flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user
to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of
sufficient magnitude to constitute a risk of electric shock to persons.
The exclamation point within an equilateral triangle is intended to alert the user to the presence
of important operation and maintenance (servicing) instruction in the literature accompanying the
appliance.
Indicates a potentially hazardous situation which, if mishandled, could
result in moderate or minor personal injury, and/or property damage.
5