Tv Basic Operation - JVC AV-24F704 Manuel D'instructions

TV BASIC OPERATION

Before operate your TV select TV position of the TV/CATV
switch on the remote to control the TV with the remote.
1
To turn on the TV, press the POWER button.
2
The VOLUME can be adjusted to a desired level by
pressing the VOL (VOLUME) + or – button.
Adjust the volume level by
pressing the VOLUME + or –
button. The volume level will
be indicated on the screen by
green bar. As the volume level
increases, so do the number of
bar. If the volume decreases,
the number of green bar also decreases.
The sound level will be indicated on the TV screen by
green bars and a number. As the sound level in-
creases, so do the number of bars and the number on
the screen. The same is true for decreasing the level.
3
Set the TV/CATV menu option to the appropriate
position. When shipped from the factory, this menu
option is in the CATV setting. See
"
CHANNELS .
TV - VHF/UHF channels
CATV - CABLE TV channels
4
CH (CHANNEL) + and – buttons
Press and release the CH
(CHANNEL) + or – button. The
channel automatically stops at the
next channel set into memory.
For proper operation, before selecting channels,
they should be set into the TV's memory.
See "TO MEMORIZE CHANNELS".
RETURN button
Returns to the channel viewed just before the channel
currently onscreen.
MUTING button
VOLUME 32
The MUTING button instantly turns the
volume down completely when you
press it.
Press MUTING button and the volume
level will instantly go to zero. To restore
the volume to its previous level, press MUTING button again.
10-key pad (0-9)
Press these buttons to select a channel. The channel
number will appear on the upper right corner of the TV
screen. If an invalid channel number is selected, the display
will revert to the original channel.
" TO MEMORIZE
TV Mode Direct Channel Selection
When the TV/CATV menu option is in the TV position, all
channels can be instantly selected by using two buttons.
(For example, to select channel 2, press
press only
seconds). For channels 10 and above, press the 2 digits in
order.
CH 012
CATV Mode Direct Channel Selection
When the TV/CATV menu option is in the CATV position,
channels can be selected as follows:
NOTE: If the station being viewed stops broadcasting, the
CH 012
" "
2 , channel selection will be delayed for a few
CH. 1-9
Press "0" twice, then 1-9 as needed.
Example, to select channel 2, press
"002".
CH. 10-12
Press "0", then remaining 2 digits.
Example, to select channel 12, press
"012".
CH. 13-99
Press the 2 digits in order.
Example, to select channel 36, press
"36".
CH. 100-125
Press the 3 digits in order.
Example, to select channel 120, press
"120".
TV will automatically shut off after 15 minutes.
CH 007
MUTING
" 0 " , then " 2 " . If you
17