Technical Information - AEG FAVORIT 88072 VI Notice D'utilisation

32 www.aeg.com
Stains and dry water drops on glasses
and dishes
• The released quantity of rinse aid is
not sufficient. Adjust the rinse aid se-
lector to a higher position.
• The quality of the detergent can be
the cause.
Dishes are wet
• The programme is without a drying
phase or with a low temperature dry-
ing phase.
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the
cause.
• The quality of the combi detergent
tablets can be the cause. Try a differ-
ent brand or activate the rinse aid dis-
penser and use rinse aid together with
the combi detergent tablets.
Refer to 'HINTS AND TIPS' for
other possible causes.
10.2 Activating the rinse aid
dispenser with the multitab
option activated
1. Press the on/off button to activate
the appliance. Make sure that the ap-

11. TECHNICAL INFORMATION

Dimensions
Electrical connection
Water supply pressure
Water supply
Capacity
Power consumption
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
2) If the hot water comes from alternative sources of energy, (e.g. solar panels, aeolian
energy), use the hot water supply to decrease energy consumption.
Width / Height / Depth
(mm)
Refer to the rating plate.
Voltage
Frequency
Min. / max. (bar / MPa)
1)
Cold water or hot water
Place settings
Left-on mode
Off-mode
pliance is in setting mode, refer to
'SETTING AND STARTING A PRO-
GRAMME'.
2. Press and hold touchpads (4) and (5)
at the same time until the indicators
of touchpads (3), (4) and (5) start to
flash.
3. Press touchpad (4).
• The indicators of touchpads (3)
and (5) go off.
• The indicator of touchpad (4) con-
tinues to flash.
• The display shows the setting of
the rinse aid dispenser.
4. Press touchpad (4) to change the set-
ting.
5. Deactivate the appliance to confirm
the setting.
6. Adjust the released quantity of rinse
aid.
7. Fill the rinse aid dispenser.
596 / 818 - 898 / 550
(0.5 / 0.05 ) / (8 / 0.8 )
2)
Off
On
220-240 V
50 Hz
max. 60 °C
12
0.10 W
0.10 W