Warranty Coverage; Maintenance Table; Problem Identification - Alpina AS 5148 Li Manuel D'utilisation

• The authorized service workshops
only use genuine spare parts. Genuine
spare parts and accessories have been
designed specifically for machines.
• Non-genuine spare parts and accessories are
not approved. Use of non-genuine spare parts
and accessories cause the warranty to expire.
• It is advisable to send your machine
once a year to an authorized service
workshop for servicing, assistance
and safety device inspection.

11. WARRANTY COVERAGE

The warranty covers all material and
manufacturing defects. The user must
follow all the instructions provided in
the accompanying documentation.
The warranty does not cover
damages caused by:

12. MAINTENANCE TABLE

Safety checks/check controls
Always check the electric devices are intact and working properly
Check the auger rotates freely
Apply silicone spray on the auger, to avoid ice formation
Check all the screw connections are tight. Tighten, if necessary.
Check the starter lever is only activated on
release of the disengaged starter lever
General cleaning and inspection

13. PROBLEM IDENTIFICATION

PROBLEM
1. No start
2. The motor barely rotates
3. The motor stops
suddenly
Intervention
PROBABLE CAUSE
Battery is not inserted or is inserted
incorrectly
Overload protection activated
The auger is on and the motor cannot start. Immediately release the start
Auger or discharge chute
obstructed, blocked by obstacles or
damaged.
The capacitor is faulty.
Electric part malfunction
Overload protection activated
• Failure to become familiar with the
documentation accompanying the machine.
• Carelessness.
• Incorrect or prohibited use or assembly.
• Use of non-genuine spare parts.
• Use of accessories not supplied or
approved by the manufacturer.
The warranty does not cover:
• Normal wear and tear of consumables,
such as drive belts, drills, headlights,
wheels, bolts and wires.
• Normal wear and tear.
• Motors. Motors are covered by the
warranty provided by the relative
manufacturer in compliance with the
specified terms and conditions.
The purchaser is protected by his own national
legislation. The purchaser's rights envisaged
by the national laws in his own country are
not in any way restricted by this warranty.
Before each use
Before each use
Before each use
Before each use
Before and after each use
Before each use
At the end of each operation
Check that the battery is correctly inserted
Wait a few seconds for automatic reset.
control and remove the obstacle.
Try and switch on again.
Clean the auger and chute. Remove any
dirt or foreign bodies. Replace if damaged.
Call assistance or the dealer.
Call assistance or the dealer.
Wait 10 minutes and try again.
EN - 11
Frequency
REMEDY
Paragraph
6.2
6.2
6.2.1
6.3
4
5.3
8.2