Overheating Protection; Technical Data - Toolland TC 78050 Mode D'emploi

TC 78050
Plug in the appliance.

Turn the thermostat to maximum.

Turn on the heater:

- Switch 1 = 750W
- Switch 2 = 1250W
- Switch 1 + 3 = 2000W
When the heating elements are switched

on the lights will be illuminated.
When the desired temperature has been

reached, the thermostat knob should be
turned slowly anti-clockwise until a click
of the thermostat is heard. The
thermostat will keep the temperature
from now on.
When the temperature declines the

thermostat will be switched on
automatically until the desired
temperature is reached again.
To switch off the appliance you must put

the thermostat on 0 and switch off the
switches. Always unplug the appliance.
TURBO
The appliance is equipped with an internal fan
that can be switched on independently of the
heating elements. With this you can circulate
the heat much faster in the room.

OVERHEATING PROTECTION

The internal overheating protection will be
activated automatically when the appliance is
overheated. In this case you must unplug the
appliance. After a period of cooling down you
can use it again. When the overheating
protection is activated for several times you
must contact your local dealer.

TECHNICAL DATA

Voltage
Frequency
Power
Positions
Turbo fan
Thermostat
Overheating protection
Dimensions
Warranty
MAINTENANCE
Before cleaning, unplug the appliance.

Never use water for cleaning.
Use a moist rag for cleaning.

Do not immerse the appliance in water.

Toolland | www.toolland.be
230
50
2000W
3
Yes
Yes
Yes
584x200x418mm
2 year
Do not touch the appliance immediately

after it has stopped working. It could be
very hot.
ENVIRONMENT
Should your appliance need replacement
after extended use, do not put it in the
domestic waste but dispose of it in an
environmentally safe way.
GUARANTEE
Refer to the enclosed guarantee conditions
for the terms and conditions of guarantee.
English
12