Aerus Origins WC300 Manuel D'utilisation page 21

Step 4: Set Regen Time
• 2:00 (AM) is the default time of regeneration. To accept this
time, press the DOWN button to move to step 5.
• To change the regen time, press SET – causing "2:00" to
flash.
• Use the UP and DOWN buttons to advance to the desired
regen time.
• Press SET to accept the time and advance to the next
parameter.
After steps 1-4, the controller will operate most systems. Proceed
to step 5 if further adjustments to your system's programming is
needed.
SU MO
Time & Day
Regen Time & Day
Salt
Capacity
Hardness
Figure 26
Step 5: Set Calendar Override
• Set number of days for calendar override on demand
control.
• "0" days is the default for calendar override.
• Days can be adjusted from ½ (.5) to 99 days.
• To change, press SET to make the "0" flash.
• Use the UP and DOWN buttons to change to the number of
days desired. Press SET to accept the regen frequency, and
advance to the next cycle.
SU MO
Time & Day
Regen Time & Day
Salt
Capacity
Hardness
Figure 27
TU WE TH FR SA DAYS
TU WE TH FR SA DAYS
Step 6: Amount of Regenerant used per
Regeneration
• Set desired regenerant amount.
• Default setting is "S" standard salting.
• 3 salt settings are available on 740 and 760 controls:
• S – Standard Salt – 9 lbs/cubic foot of resin (120 grams/
liter of resin)
• H – High Salt – 15 lbs/cubic foot of resin (200 grams/liter
of resin)
• L – Low Salt – 3 lbs/cubic foot of resin (40 grams/liter of
resin)
• Low Salt is the "Highly Efficient Mode".
• To change salt setting, press the SET button and use the UP
and DOWN buttons to change to the desired setting.
• Press SET to accept the setting and advance to the next
parameter.
SU
Time & Day
Regen Time & Day
Salt Amount
Capacity
Hardness
SU MO
Time & Day
Regen Time & Day
Salt Amount
Capacity
Hardness
SU
Time & Day
Regen Time & Day
Salt Amount
Capacity
Hardness
21
MO TU WE TH FR SA
TU WE TH FR SA
MO TU WE TH FR SA
Figure 28
DAYS
DAYS
DAYS