Publicité
User Manual
Introduction
Thank you for purchasing the LINDY 2 Port DisplayPort Splitter with expander function. This product
has been designed to provide trouble free, reliable operation. It benefits from both a LINDY 2 year
warranty and free lifetime technical support. To ensure correct use, please read this manual carefully
and retain it for future reference.This device is a high performance DisplayPort MST hub (Multi Stream
Transport) which allows one DisplayPort source to be shown simultaneously on 2 displays or similar as
an extended desktop across 2 displays. The MST hub splits the MST input signal into two single
streams to the individual monitors. It detects how many displays are connected and allows to send 2
monitor signals over one DP cable to the Splitter. The computer's graphic card settings panel will show
2 monitors.
IMPORTANT: The DP Expander splitter / MST hub can only work with DP 1.2 graphic cards, DP 1.1
input signals are not supported! This product is significantly different compared to VGA or HDMI
splitters!
Package Contents
LINDY 2 Port DP Expander Splitter / MST Hub
5V DC multi-country power supply
This manual
Features
Supports DisplayPort 1.2 input signals up to 3840x2160@60Hz
Maximum output resolution (depending on the monitors) with 2 displays:
3840x2160@30Hz or 2560x1600@60Hz
The MST function splits the combined MST input signal up into two single monitor streams
Monitors with different resolutions can be used as long as within the above limits
HBR2/HBR/RBR link rate, up to 5.4 Gbps per lane (4 lanes at 21.6Gbps) bandwidth
Supports cable lengths of up to 10m in and out with high quality LINDY SLD or GOLD cables,
depending on the resolution
Please note that the Expander splitter / MST hub cannot output 2x 3840x2160@60Hz, because the
total resolution of the two monitors cannot exceed 3840x2160@60Hz.
Installation and Operation
The LINDY DisplayPort Expander Splitter / MST Hub is a plug and play device that does not need to be
configured with software or driver support. Resolutions are configured on the computers graphic card
setting panel.
1. Connect the splitter and the two monitors to your graphics card using DP cables.
2. Connect the power adapter to the DP Expander Splitter and switch on all devices.
3. The graphic card settings panel on your PC will show two new separate monitors. Adjust the resolution
on your PCs graphics card tool. Use "Duplicate Desktop" setting to show identical screen content on
both monitors (splitter function) or use "Extended Desktop" to show different content.
If you cannot see any picture please make sure that your graphic card supports DP 1.2 and MST function.
Try to connect one monitor only and try to set up the required resolutions. Please regard the maximum
resolutions as listed above.
English
Publicité
