Hendi 240601 Mode D'emploi page 8

After use
• Turn the "Temperature dial" to point downwards.
• Switch OFF the appliance by pressing the ON /
OFF switch (1).
Dispensing
• Place a suitable cup as close as possible under
the tap.
• Push down the lever on the tap to dispense the
desired amount of liquid.
RESET the Hi-limiter (Dry-boiling protection)
Please note that there is a RESET button located
at the bottom of the appliance (marked RESET la-
bel). This acts as dry-boiling protection for the ap-
pliance.
Cleaning and Maintenance
Attention: Always unplug the appliance from the electrical power outlet and let it cool down completely before
cleaning & storage.
Cleaning
EN
• Clean the appliance before and after each use.
• Never immerse the appliance in water or other
liquids.
• Do not clean the appliance with a water jet.
• Flush the drain tap (4) thoroughly.
• Clean the surface with a slightly damp cloth or
sponge with some mild soap solution.
Descaling
• Hard water may cause some deposits to form in-
side the container and cause possibly damage to
the appliance.
• Thus, descale the appliance regularly. The des-
caling intervals depend on water hardness and
frequency of use. Use only commercially availa-
ble descaling agents and follow the instructions
of the manufacturer.
Storage
• Before storage, always make sure the appliance
has already been disconnected from the electri-
cal outlet and cooled down completely.
8
Note: Always turn the "Temperature dial" to point
downwards and press the ON/OFF switch (1)
to the "0" position before unplug it.
• Pull back the lever after finishing the dispensing.
• Switch OFF the appliance and unplug it.
• Allow the appliance to cool down completely.
• Discard the liquid if any.
• Press the RESET button.
• The appliance is ready for use again.
• All washed parts should be rinsed with clean wa-
ter to remove the cleaning residues.
• Never use abrasive sponges or detergents, steel
wool or metallic utensils to clean the interior or
exterior parts of the appliance.
- Fill the container with water and appropriate
amount of descaling agent up to MAX level.
- Start boiling the solution.
- After boiling, dispose of the solution of water
and descaling agent properly.
• Rinse the container and boil twice to remove any
residues.
• Store the appliance in a cool, clean and dry place.