Hendi 240601 Mode D'emploi page 6

Masquer les pouces Voir aussi pour 240601:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 36
Preparations before first use
• Remove all protective packaging and wrapping.
• Check to make sure the appliance is undamaged.
In case of incomplete delivery and damages, DO
NOT use the appliance. Please contact supplier
(See ==> Warranty).
• Installation of the lift up handles (8) and drain tap
(4). (See ==> Installation of drain tap and handles
session).
• Clean the appliance before use (See ==> Cleaning
and Maintenance).
• Make sure the appliance is completely dry.
Installation of drain tap
• First, put the black seal ring on the drain tap.
EN
• Next, insert this sub-assembly into the hole of
the container (7) .
6
• Place the appliance on a horizontal, stable and
heat resist surface that is safe against water
splashes.
• Ensure that there is sufficient ventilation. Keep
a minimum distance of 20 cm around the appli-
ance.
Note: Due to manufacturing process, the appliance
may emit a slight odor and smoke in the first
few cycles. This is normal and does not indi-
cate any defect or hazard. Discard the water
from the first few cycles to remove any resi-
dues from the manufacturing process.
• Then, put a white seal ring on the drain tap (8)
from interior of the container (7).
• After this, fasten this drain tap with a nut firmly
inside the container (7).
• IMPORTANT: Make sure it is fastened firmly to
avoid leakage.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

240700

Table des Matières