Adjusting Moveable Kickplate - AGA marvel AELTTDW Instructions D'installation

Readjusting Leveling Legs
A
B
C
o
A
s
A
o
p
t
s
INSTALLATION
Adjusting the Movable Kickplate
Now that you have successfully
installed the dishwasher, you need to
attach the kickplate to the dishwasher.
The two-piece kickplate can be
adjusted to the height and depth
needed for your kitchen. Be sure to
use the slotted kickplate in the front
and the other behind it. They slide into
each other.
1. Insert the movable kickplate
brackets into the channel (A).
2. Make sure that the plastic tab to
the left of the "L" opening on the
dishwasher has not closed the
channel you will push the bracket
through.
3. Now attach the kickplate to
the bracket with the two (Ø
3/16"x1/4"-Ø 4mmx6mm) screws
and the caps provided as follows.
B
t
C
B
C
Now that the dishwasher is in the cabinet, you must
readjust the leveling legs to bring the dishwasher up
to the required height and attach it underneath the
countertop.
• Readjust the front leveling leg with adjusting
wrench to balance the dishwasher and raise it up
under the countertop; make sure the unit is level.
• Readjust the rear leveling leg with a screwdriver to
balance the dishwasher and raise it to the required
height using the brackets supplied.
• Attach the dishwasher underneath the countertop
with the four screws supplied (Ø 1/8"x1/8"-Ø
3.5mmx14mm). Make sure you do not go through
the top of the countertop or damage granite.
There is a left and a right bracket.
• Adjust the kickplate brackets forward or
backwards so that they will align with
the kitchen kickplate (B).
• Lock the kickplate brackets as shown
with the plastic tab on the dishwasher
into the teeth of the bracket (C).
If the enclosure height is below 33-1/16" (84.0cm), use only
(o) labeled kickplate (kickplate without slots). Installation
should be done following the steps illustrated in the Figures
A, B, and C respectively.
1. Bend tabs on kickplate (o) inwards (A).
2. Secure kickplate to brackets with screws (t) as shown in
the supply bags (B).
3. Attach caps (s) as shown in the supply bags (C).
If the enclosure height is above 33-1/16" (84.0cm), use "o"
and "p" labeled kickplates together. Make sure the slotted
kickplate (p) is on the outside so you can adjust height of
the kickplate. Installation should be done following the steps
illustrated in the figures A, B, and C respectively.
1. Align the kickplate (o) and (p) (A).
2. Secure kickplates to brackets with screws (t) after
adjusting the height of the slotted kickplate (p) (B).
3. Attach caps (s) as shown in the supply bags (C).
15
WARNING
DANGER
CAUTION
NOTICE
FOR YOUR SAFETY