Location Of Parts; Installation Instructions; Before Using Your Appliance; Installation Of Your Appliance - Summit SCR321LWC2 Mode D'emploi

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

Interior Light

Full Shelf (Total 3)

Half Shelf (Total 1)

Levelling Legs

NOTES: 1. Models with BI in the model number suffix can be installed either built-in or free-standing.

2. Models with CSS in the model number suffix have cabinets fully wrapped in stainless steel.

3. The metal insert for wine cellars allows you to lay 3 Bordeaux bottles or 2 Burgundy bottles

safely on the floor.

4. Shelves for wine cellars are wooden. Those for beverage merchandisers are chrome-

plated wire.

BEFORE USING YOUR APPLIANCE

• Remove the exterior and interior packing.

•

CAUTION: After unpacking and

allow this appliance to stand upright for at least 2 hours to allow the lubricant and refrigerant to

drain back into the compressor and stabilize. Failure to do so may adversely affect performance

and the lifetime of the unit.

• Clean the interior surface with lukewarm water using a soft cloth.

• Install the handle on the door. (See page 7.)

INSTALLATION OF YOUR APPLIANCE

• Your appliance is designed to be free-standing, but can be built-in (fully recessed) if the model number

includes the letters "BI". If free standing, the unit should have at least 4" (102 mm) of clearance at both

sides, at the top and at the back to allow for adequate ventilation. Built-in models do not require any

additional clearance, as they include an exterior collar and rear fan that ensure the unit is properly

ventilated.

• WARNING: Do not store or install the appliance outdoors.

• CAUTION

This appliance is designed for storing and cooling bottles of wine or other beverages. Do

not store perishable food, medicine or other medical products.

• Place your appliance on a floor that is strong enough to support it when it is fully loaded. To level the