Working Advice; Maintenance And Service; Maintenance And Cleaning; After-Sales Service And Application Service - Berner BHD-2/26 830 W Notice Originale

OBJ_BUCH-3323-001.book Page 20 Tuesday, September 19, 2017 4:15 PM
Overload Clutch
 If the tool insert becomes caught or jammed,
the drive to the drill spindle is interrupted. Be-
cause of the forces that occur, always hold the
power tool firmly with both hands and provide
for a secure stance.
 If the power tool jams, switch the machine off
and loosen the tool insert. When switching the
machine on with the drilling tool jammed, high
reaction torques can occur.

Working Advice

 Before any work on the machine itself, pull the
mains plug.
Changing the Chiselling Position (Vario-Lock)
The chisel can be locked in 36 positions. In this
manner, the optimum working position can be set
for each application.
– Insert the chisel into the tool holder.
– Turn the mode selector switch 11 to the "Vario-
Lock" position (see "Setting the operating
mode", page 19).
– Turn the tool holder to the desired chiselling po-
sition.
– Turn the mode selector switch 11 to the "chisel-
ling" position. The tool holder is now locked.
– For chiselling, set the rotation direction to right
rotation.
Inserting Screwdriver Bits (see figure J)
 Apply the power tool to the screw/nut only
when it is switched off. Rotating tool inserts can
slip off.
To work with screwdriver bits, a universal bit holder
22 with SDS-plus shank (accessory) is required.
– Clean the shank end of the adapter shank and
apply a light coat of grease.
– Insert the universal bit holder with a turning mo-
tion into the tool holder until it automatically
locks.
– Check the locking effect by pulling the universal
bit holder.
– Insert a screwdriver bit into the universal bit hold-
er. Use only screwdriver bits that match the
screw head.
– To remove the universal bit holder, pull the lock-
ing sleeve 5 toward the rear and remove the uni-
versal bit holder 22 out of the tool holder.
1 609 92A 41X • 19.9.17

Maintenance and Service

Maintenance and Cleaning

 Before any work on the machine itself, pull the
mains plug.
 For safe and proper working, always keep the
machine and ventilation slots clean.
 A damaged dust protection cap should be
changed immediately. We recommend having
this carried out by an after-sales service.
– Clean the tool holder 3 each time after using.
If the replacement of the supply cord is necessary,
this has to be done by Berner or an authorized
Berner service agent in order to avoid a safety haz-
ard.
After-sales Service and Application
Service
In all correspondence and spare parts orders,
please always include the 6-digit order number giv-
en on the nameplate of the machine.
Disposal
The machine, accessories and packaging should
be sorted for environmental-friendly recycling.
Do not dispose of power tools into house-
hold waste!
Only for EC countries:
According to the European Guideline
2012/19/EU for Waste Electrical and Elec-
tronic Equipment and its implementation
into national right, power tools that are no
longer usable must be collected separately and
disposed of in an environmentally correct manner.
Subject to change without notice.
English | 20