Console And Key Functions - Klarfit Relaxbike 6.0 SE Mode D'emploi

CONSOLE AND KEY FUNCTIONS

Press the button briefly to select a function. Press and hold the button to reset
the TIME, DISTANCE, or CALORIES values.
SCAN
Press the MODE button until an arrow appears at the SCAN position. The
monitor will display the following values in sequence (6 seconds each): TIME >
SPEED > DISTANCE > CALORIES > PULSE.
• TIME: Count the total time from start to finish.
• SPEED: Displays the current speed.
• DISTANCE: Count the distance from start to end of training.
• CALORIES: Count the total calories from start to end of workout.
PULSE
Press the MODE button until an arrow appears at the PULSE position. To
measure the pulse rate, place your palms on the two contact surfaces on the
handlebars. The display will show the current heart rate in beats per minute
(BPM) after 6-7 seconds. While the heart rate monitor is running, the reading
may be higher than the actual heart rate in the first 2-3 seconds. The longer
the pulse is measured, the more accurate the display will be.
Notes on the console
• If the display is weak or shows no numbers, replace the batteries.
• The monitor will automatically turn off if no signal is received after 4
minutes.
• The monitor will automatically turn on when you start exercising.
• The monitor automatically starts calculating when you start training and
stops calculating 4 seconds after you finish training.
EN
45