Cutting Warped Material - Rigid R4113 Manuel D'utilisation

OPERATION
To install the sliding miter fences in their normal operat-
ing position:
 Loosen the fence screw and slide the miter fences toward
the saw arm until they stop.
NOTE: The fixed screws prevent the sliding miter fences
from sliding too close to the saw arm and possibly inter-
fering with the movement of the blade. Do not remove
fixed screws.
 Remove the sliding miter fences by pulling them up and
away from the miter table.
 Place the left sliding miter fence on the left side of the
tool and the right sliding miter fence on the right side with
both fences facing the front of the tool.
 Install the miter fences by aligning the large slot in the
fences with the fence screw on the saw and pushing
down.
 Tighten the fence screws to secure the fences in place.

CUTTING WARPED MATERIAL

See Figures 41 - 42.
When cutting warped material, always make sure it is posi-
tioned on the miter table with the convex side against the
fence as shown in figure 42.
SLIDING
MITER FENCE
FENCE
SCREW
VIEW OF SAW FROM FRONT WITH FENCES
FACING FORWARD
If the warped material is positioned the wrong way as shown
in figure 41, it will pinch the blade near the completion of
the cut.
WARNING:
To avoid a kickback and to avoid serious personal
injury, never position the concave edge of bowed
or warped material against the fence.
Fig. 40
29 - English
WRONG
Fig. 41
RIGHT
Fig. 42