Rigid R4113 Manuel D'utilisation page 18

ASSEMBLY
 Turn the fence screws counterclockwise 2-3 times to
loosen and slide miter fences toward the saw arm until
they are flush with the miter table.
 Remove the sliding miter fences by pulling them up and
away from the miter table.
 Using the supplied 5 mm hex wrench, loosen the socket
head screws that secure the fence to the miter table.
See figure 18.
 Rotate the fence left or right until the saw blade is parallel
with the square.
FENCE
SOCKET
HEAD SCREW
SLIDING
MITER FENCE
SLIDING
MITER FENCE
FENCE
SOCKET
HEAD SCREW
Fig. 18
 Retighten the screws securely. Check blade squareness
to fence and readjust if necessary.
 Replace the sliding miter fences.
Your saw has several scale indicators. After squaring adjust-
ments have been made, it may be necessary to loosen the
indicator screws and reset them to zero. See Figures 19 - 20.
INDICATOR
SCREW
SCALE
INDICATOR
FENCE
SCREW
Fig. 17
BEVEL SCALE
18 - English
MITER
SCALE
SCALE
INDICATOR
INDICATOR
SCREW
Fig. 19
Fig. 20