Rigid R4113 Manuel D'utilisation page 15

ASSEMBLY
TO INSTALL THE BLADE
See Figure 12.
WARNING:
A 10 in. blade is the maximum blade capacity of
the saw. Never use a blade that is too thick to allow
outer blade washer to engage with the flats on the
spindle. Larger blades will come in contact with the
blade guards, while thicker blades will prevent the
blade bolt from securing the blade on the spindle.
Either of these situations could result in a serious
accident and can cause serious personal injury.
 Unplug the saw.
 Raise saw arm and rotate lower blade guard up.
 Using the Phillips screwdriver end of the blade wrench,
loosen, but do not remove, the blade bolt cover screw.
Slide blade bolt cover toward upper blade guard to expose
the blade bolt.
 Depress the spindle lock button and rotate the blade bolt
until the spindle locks.
 Using the hex end of the blade wrench, loosen and remove
the blade bolt.
NOTE: The blade bolt has left hand threads. Turn blade
bolt clockwise to loosen.
 Remove the outer blade washer. Do not remove the inner
blade washer.
 Wipe a drop of oil onto the inner blade washer and the
outer blade washer where they contact the blade.
WARNING:
If inner blade washer has been removed, replace
it before placing blade on spindle. Failure to do
so could cause an accident since blade will not
tighten properly.
 Fit saw blade inside upper blade guard and onto spindle.
The blade teeth point downward at the front of saw as
shown in figure 12.
 Replace the outer blade washer. The double "D" flats on
the blade washers align with the flats on the spindle.
 Depress spindle lock button and replace blade bolt.
NOTE: The blade bolt has left hand threads. Turn blade
bolt counterclockwise to tighten.
CAUTION:
Always install the blade with the blade teeth and
the arrow printed on the side of the blade pointing
down at the front of the saw. The direction of blade
rotation is also stamped with an arrow on the upper
blade guard.
BLADE BOLT
NOTE : BEFORE USE,
ENSURE SCREW IS
TIGHTENED SECURELY
TO PREVENT GUARD
MOVEMENT
OUTER BLADE
WASHER WITH
DOUBLE "D" FLATS
BLADE
BOLT
TO
LOOSEN
TO
TIGHTEN
BLADE
WRENCH
 Tighten blade bolt securely.
 Replace blade bolt cover and tighten blade bolt cover-
screw securely.
 Lower the blade guard.
 Raise and lower the saw arm to ensure lower blade guard
functions correctly.
15 - English
BLADE
OUTER
BLADE
WASHER
BLADE BOLT
COVER SCREW
LOWER
BLADE GUARD
BLADE BOLT
INNER BLADE
WASHER WITH
DOUBLE "D" FLATS
BLADE
ARBOR
INNER
BLADE
WASHER
COVER
Fig. 12