Quick Start - NEC AccuSync LCD22WMGX Manuel Utilisateur

LCD22WMGX
1
2
3
4
5
6
7
8
9
10

Quick Start

Stand
Locking Tabs
Base
Figure S.1
Figure A.1 Figure A.2
Power Cable
Cable holder
Figure B.1
01_English
SPDIF OUT Outputs the Digital audio signal from HDMI (COAXIAL).
Component (Audio) Connects Component Audio.
Component (Video) Connects Component Video.
Headphone Jack Connects headphones to the monitor.
AUDIO IN Connects audio input from PC.
D-SUB Connects to analog RGB input.
DVI-D Connects to digital RGB input.
HDMI Connects to digital HDMI signals.
AC IN Connects power cord to monitor.
Kensington Lock Opening Monitor can be secured using a Kensington locking system.
Figure A.3
Macintosh Cable Adapter
(not included)
Input (HDMI)
Input (DVI)
Input (VGA)
Headphone
Audio Cable
2
LCD24WMCX
To attach the Base to the LCD Stand:
1. Insert the front of the LCD stand into the holes in the front of the
Base (Figure S.1).
2. Attach the Base to the Stand. The locking tab on the Base should
fit into the hole on the back of the Stand (Figure S.1).
To attach the LCD monitor to your system, follow these instructions:
1. Turn off the power to your computer.
2. For the PC or MAC with DVI digital output: Connect the DVI
signal cable to the connector of the display card in your system
(Figure A.1).
For the PC with Analog output: Connect the 15-pin mini D-SUB
signal cable connected with the monitor to the connector of the
display card in your system (Figure A.2). Tighten all screws.
For the Mac: Connect the MultiSync Macintosh cable adapter
(not included) to the computer. Attach the 15-pin mini D-SUB
signal cable to the MultiSync Macintosh cable adapter
(Figure A.3). Tighten all screws.
NOTE: Some Macintosh systems do not require a Macintosh cable
adapter.
3. Connect one end of the power cord to the monitor and the other
end to the power outlet. Use the Cable holder to keep the Video
Signal Cable, Audio cable and power cord together (Figure B.1).
4. To attach the Cable Holder:
Attach the Cable Holder on to the Base. Insert the hooks on the
Cable Holder into the holes at the back of the Stand and slide the
Cable Holder downward into place (Figure B.1).
NOTE: Please confirm that the tabs are completely secure.
NOTE: Adjust position of cable that place under the Cable holder to
avoid damage for cable or monitor.
NOTE: Please refer to Caution section of this manual for proper
selection of power cord.
English-2
25/9/07, 12:15 PM