Table des Matières
Publicité
FRAME
EN
1 Unpack the stroller frame from the box
and set the wheels aside. Unlock the
stroller by pulling the
Storage Lock Lever.
2 Lift the Handlebar away from the lower
frame. The stroller will click into place.
3 Place the stroller in the upright position.
WARNING: Ensure that all the locking
devices are engaged before use.
FRONT WHEEL
4 Installation
• Lay stroller on its back so the Handlebar
is resting on the floor.
• Attach the Front Wheel by sliding it into
the front wheel mount until it clicks.
Gently pull on the Front Wheel to make
sure it is properly attached.
5 Removal
• While pressing the front wheel release
button, gently slide the Front Wheel out
of the front wheel mount.
SWIVEL FEATURE
6 Press the Swivel Lock button down and
slide the Swivel Lock to the left to lock the
front wheel assembly in a fixed position
for long distance strolling.
7 Press the Swivel Lock button down and
slide the Swivel Lock to the right to allow
the front wheel assembly to swivel.
WARNING: When loading and
unloading child, lock the front wheel in
a fixed position. Although the
front wheel of your stroller locks, it is
not intended for jogging or exercise
purposes.
REAR WHEELS
8 Installation
• Align the Rear Wheel axle with the wheel
mount on the stroller frame and insert it
into the wheel mount until it clicks into
place.
• Gently pull on the Rear Wheel to make
sure it is properly attached.
9 Removal
• While pressing the Wheel Release
Button, gently slide the Rear Wheel out
of the wheel mount.
BRAKE
10 To engage the brake squeeze on the
brake lever.
11 To Lock the Parking Brakes: gently push
the Brake Lever forward until it clicks into
place.
12 To Release the Brakes: Pull the Parking
brake release button towards you.
WARNING: Lock the brakes before loading
and unloading your child and whenever the
stroller is not moving.
13 If the rear wheels are not breaking together
evenly, you may adjust the stroller's brakes.
The brake for the wheel that continues
to spin even while breaking must be
tightened: Locate the adjuster on the wheel
hub (A) with the loose brakes. Loosen
the brake's short ring (B) to adjust the
long cylinder ring (C). Unscrew the long
cylinder ring further from the wheel hub (A)
to tighten the cable. (Please do not over
tighten!) To lock the rings, tighten the short
ring (B) against the wheel hub (A) while
holding the long cylinder ring (C) in place.
Squeeze the Hand Brake gradually to give
you better control over your stroller.
SEAT - UNFOLD THE SEAT
14 Holding the footwell and the top of the
seat, open the seat.
15 The seat will lock into its open position.
CANOPY
16 Attach the canopy to the frame: Attach the
Canopy's brackets to the sides of the seat
frame.
17 Attach the 2 fastening strips on the
canopy to the top of the seat.
ADJUSTING SAFETY HARNESS
18 From the back of the seat, undo the
fastening strip and open the pocket to
locate the plastic square stopper. Turn
stopper and pass through the openings in
the PE board and seat fabric.
10
Publicité
Table des Matières
