B3000 Set-Up & First Brew
IMPORTANT: You cannot use your Keurig
brewer until it has been primed for its first use
as set forth below.
Priming your Brewer
1. Unwrap cord and plug the brewer into a
grounded outlet.
2. Place a cup or mug (10 oz Min) on the Drip
Tray Plate (if not done the brewer will
prompt for the cup or mug later in the
priming sequence).
3. Press power switch (see Page 6) to ON
position.
4. At power up and the brewer is new the
following is displayed:
KEURIG B3000
BREWING SYSTEM
(At this stage you can go into MENU MODE
to set the default language or input the
service phone number. To enter the MENU
MODE proceed to page 15. You can also do
this anytime the brewer is in IDLE MODE.
5. The Display will automatically change to:
CONNECT WATER AND THEN
PRESS FLASHING BUTTON
6. If water is connected then press "CONT"
button which will be flashing.
7. The display will read:
PRIMING
8. Then automatically change to:
HEATING - PLEASE WAIT
8
READY – CHOOSE K-CUP
LIFT HANDLE
Español
Français
At this stage you may want to go into MENU MODE
to set the default language or input the service
phon n e number. To enter MENU MODE proceed to
page 15.
BREWING THE FIRST CUP
1. Place a cup or mug on the Drip Tray Plate.
CAUTION: There are two sharp needles
that puncture the K-Cup
one above the K-Cup
other in the bottom of the K-Cup
Holder. To avoid risk of injury, do not put
your fingers in the K-Cup
2. Brewer is now ready for normal operation.
And the display will show:
READY – CHOOSE K-CUP
LIFT HANDLE
Español
Français
3. At this stage you do any of the following:
a. Change the language for the next brew
from the default to either of the other two
languages displayed, just press the button
below the language of your choice.
b. Dispense hot water, just press and hold the
button below HOT WATER.
c. Choose a K-Cup, lift handle and insert it in
the K-Cup holder.
INSERT NEW K-CUP
LOWER HANDLE
4. Place a K-Cup
®
portion pack in the K-Cup
Holder.
HOT
WATER
portion pack,
®
Holder and the
®
®
Chamber.
®
HOT
WATER
®