The Deluxe Seat P - Mutsy 4Rider Mode D'emploi

Removing the carry cot
· Push the two release buttons of the uni-
versal fixation points in forward direc-
tion until the carry cot is released. You
can now remove the carry cot from the
frame.
· The carry cot can also be removed from the
support frame. To do this, release the
clamps on both sides of the carry cot. Now
the carry cot with the child in it can be
taken from the frame. The carry cot can
be carried using the grip of the canopy.
! Regularly check the bottom of the carry
cot on wear.
The canopy
· The canopy of this carry cot is fixed.
The canopy can be adjusted by pushing
it forward.
· To close the canopy you have to press
the buttons on both sides and move the
canopy backwards.
The apron
· To assemble the apron, fix the press
buttons on the indicated positions.
· To remove the apron, loosen the press
buttons on the indicated positions.
The Deluxe seat (0-15 kg)
· This seat can be assembled into 2 di-
rections and backrest and footrest can
be adjusted in various positions.
Assembly on the frame (l)
· Place the seat with the fastening parts
(L+R) above the universal fixation
points of the frame. Push the seat down
until it firmly clicks. Make sure that the
seat is fixed properly and that the red
surfaces in the universal fixation points
are fully covered.
! Both ends (L+R) of the seat support
hooks under the seat should always fall
in front of the support-construction.
Assembly on the frame (the child faces
the parent)
· Place the seat with the fastening parts
(L+R) above the universal fixation
points of the frame. Push the seat down
until it firmly clicks. Make sure that the
seat is fixed properly and that the red
surfaces in the universal fixation points
are fully covered.
! Under the seat there is a Velcro strip
that is attached to the backside of
the seat with a press button. When
you put the seat in the position that
the child faces the parent, the Velcro
strip should be fastened around the
cross-connection and the support-
construction to avoid movement of
the seat.
Removing the seat
· Push the two release buttons of the uni-
versal fixation point in forward direc-
tion until the seat releases. Now the
seat can be taken from the frame.
! If the seat is facing the parent, the Vel-
cro strip with which the seat is attached
to the frame should be released.
The canopy (l)
· Place the canopy in the openings (L+R)
until it locks.
· To remove the canopy, press on the
small press buttons on the canopy parts
and pull the canopy out of the notches.
· Fix the clasps that are attached to the
canopy on the tube as indicated. This is
easier when you put the seat in the lowest
position before performing this action.
The bumper bar (l)
· Fix the bumper bar by placing it in the
openings in the plastic parts (L+R).
· Push the button marked "press" (L+R)
and lift the bumper bar up to remove
the bumper bar.
The dinner tray (l)
· Secure the dinner tray by slotting it in-
to the front notches (L+R) of the
pushchair seat's plastic attachments
section. Ensure the front bar is
removed first.
· To detach the dinner tray, push the
'press' buttons (L+R) and remove.
Adjusting the back rest (m)
· In order to adjust the back rest, the
press button on the right side of the
seat should be pressed and at the same
time the backrest should be moved into
the desired position.
· The backrest can be moved forward
English
19