Petromax bl1540 Mode D'emploi page 13

THE BL1540 WITH CLIP
To attach the clip to the lamp, spread it slightly and
insert it in the grooves on the side of the bl1540.
Thanks to the half-open hook on the clip, the LED lamp
can be hung, e.g. inside a tent, and raised. To change
the angle, you can move the clip in the grooves.
RECHARGE THE PETROMAX BL1540
Make sure that the wire of the power supply unit
!
is not crushed, folded or damaged by sharp edges
when recharging. Place the wire so that no one can
trip or get caught on it. Risk of injury!
1. First, connect the power supply unit with the LED
lamp by putting the round plug of the power supply
unit into the charge socket of the LED lamp. The
charge status indicator on the power supply unit
is now shining green and shows that the battery is
correctly discharging and works properly.
2. Connect now the power supply unit to a usual socket
(100 – 240 V/AC, 50/60 Hz). If necessary, use a sui-
table adapter depending on the country and type
of socket. During the entire charging process, the
charge status indicator on the power supply unit
shines red. As soon as the LED lamp is completely
charged, the indicator shines green.
3. Finally, separate the power supply unit from the
13