Listening To The Dab; Listening To The Fm Radio - Bigben TR24DAB Mode D'emploi

Radio portable fm pll / dab
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1

Listening to the DAB

Select the DAB mode with the "STANDBY / FUNCTION" button, until "DAB Mode" is shown in the
display.
The radio will automatically do a full scan of DAB+ stations. The list of stations is then stored, eliminating
the need for another full scan when the radio is turned on next time. When the scan is complete, the
stations are stored in alphabetical order. The first available station will be played back.
NOTE: If there is no DAB+ reception at any time, change the position of the unit or adjust the antenna.
Press and hold the "AMS/MODE" button for approx. 3 seconds to start a new search.
DAB Menu
Press "MENU" button to select the DAB radio menu. Press "SKIP+" or "SKIP-" button to chosse the
following DAB menus and confirm with "ENTER / CLOCK" button:
• Full scan
The radio will automatically perform a full scan of DAB+ stations.
• Manual tune
Select a frequency with "SKIP+" or "SKIP-" button. Press "ENTER / CLOCK" button to confirm.
• DRC (Dynamic Range Control)
Dynamic range compression (DRC) or simply compression is an audio signal processing operation
that reduces the volume of loud sounds or amplifies quiet sounds thus reducing or compressing an
audio signal's dynamic range.
Select an options with "SKIP+" or "SKIP-" button. Press "ENTER / CLOCK" button to confirm.
Following options are available on the display:
– DRC high: DRC turned on; default setting recommended for noisy environments.
– DRC low: DRC is set to half the normal level.
– DRC off: DRC is turned off.
• Prune
It may be that you can no longer receive some stations after a station scan or change of location. With
this function you can delete these stations from the reception list. Select "YES" and confirm with the
"ENTER / CLOCK" button.
• System
– English
– Factory Reset
– SW version

Listening to the FM Radio

1. Select the RADIO mode with the "STANDBY / FUNCTION" button, until "FM Mode" is shown in
the display.
2. For FM reception: Completely extend the telescopic antenna. Change its position to improve the
reception.
3. There are two options to search for and preset radio stations.
Automatic scan:
Important! Any preset radio stations will be overridden.
Press and hold the "AMS / MODE" button for approx.3 seconds. The system scans the entire frequency
band for radio stations. Any stations found will be preset from lowest to highest frequency.
- EN 6 -

Publicité

Table des Matières
loading

Table des Matières