Use And Functioning - PALSON Greco Mode D'emploi

26. Do not use the vacuum cleaner to clean your pets or any other animal.
27. Keep your head (eyes, ears, mouth, etc.) away from the openings when the vacuum is turned
on or plugged in.
28. If the power cord is damaged, it must be replaced by the manufacturer, its authorized technical
service, or by a qualified technician, in order to avoid a hazard.
29. When you no longer use this product, recycle it so it is disposed according to local
regulations.
WARNING:
Important:
If the hose connection, the flexible hose or metal pipe is blocked, turn off the vacuum and remove
the obstruction before restarting the unit. If the obstruction takes place at the air inlet, a red light
will turn on automatically along with the speed level indicator light.
1. Do not use the vacuum too close to heaters or radiators.
2. Before connecting the plug into the wall outlet, make sure you have dry hands.
3. Before turning on the unit, be sure to remove large or sharp objects that may damage the dust
bag or flexible hose.
4. When removing the plug from the wall outlet, pull from the plug, not from the power cord.
5. Do not use the vacuum cleaner without filters.
6. If, while using the vacuum cleaner, you notice a squeaking sound or a reduction in suction
power, stop the vacuum cleaner and, after unplugging it, clean all air filters.
Note:
In order to avoid risks, if the power cord is damaged, it must be replaced by the manufacturer, by
authorized service personnel, or by a qualified individual.
WARNING:
Hold the plug when rewinding the cord. Do not allow the plug to snap back.

USE AND FUNCTIONING

Assembling the vacuum cleaner
Note:
Always remove the plug from the wall outlet before you install or remove accessories.
1. To attach the flexible vacuum hose, connect the air inlet duct and press it until it clicks, which
will indicate that the flexible hose has been fixed in place. (fig.1)
2. To attach the telescopic metal tube to the handle of the flexible hose, put pressure on the
metal tube until the handle goes into the telescopic metal tube.
3. To attach the floor brush to the metal tube, put pressure on the metal tube connected to the
brush. Adjust the metal tube to the desired length.
VARIABLE SUCTION CONTROL
Note:
Once all accessories are set in place, unwind a sufficient length of cord and insert the plug into
the wall outlet. A yellow mark on the power cord shows the ideal length. Do not pull the cord out
beyond the red mark.
1. Insert the plug into the wall outlet.
13