Technical Specifications - VONROC LB502DC Traduction De La Notice Originale

TECHNICAL SPECIFICATIONS

Model No.
Rated voltage
No load speed
Pos 1:
Pos 2:
Max. Air Velocity
Pos 1:
Pos 2:
Weight
Sound pressure level L
PA
Sound power level L
WA
Vibration value
Only use the following batteries of the VONROC
VPOWER 20V battery platform. Using any other batte -
ries could cause serious injury or damage the tool.
CD801AA 20V, 2Ah Lithium-Ion
CD803AA 20V, 4Ah Lithium-Ion
The following charger of the can be used to charge
these batteries.
CD802AA Quick charger
The batteries of the VONROC VPOWER 20V battery
platform are interchangeable with all the VONROC
VPOWER 20V battery platform tools.
Vibration level
The vibration emission level stated in this instruc-
tion manual has been measured in accordance
with a standardized test given in EN 50636-2-100;
it may be used to compare one tool with another
and as a preliminary assessment of exposure to
vibration when using the tool for the applications
mentioned.
• Using the tool for different applications, or with
different or poorly maintained accessories, may
significantly increase the exposure level.
• The times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level.
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work pat-
terns.
WWW.VONROC.COM
LB502DC
20V
9000/min.
13000/min.
80 km/h
190 km/h
1.22 kg
78.8 dB(A) K=2.5 dB(A)
88.2 dB(A) K=1.04 dB(A
3.069 m/s K=1.5 m/s
2 2
DESCRIPTION
The numbers in the text refer to the diagrams on
page 2-3.
1. On/Off button
2. Battery (not included)
3. Battery unlock button
4. Upper tube
5. Lower tube
3. ASSEMBLY
Before any work on the power tool, remove
the battery.
The battery must be charged before first
use.
Inserting the battery into the machine (Fig. A, C)
Ensure that the exterior of the battery is
clean and dry before connecting to the
charger or machine.
1. Insert the battery (2) into the base of the machi-
ne as shown in Fig. C.
2. Push the battery further forward until it clicks
into place.
Removing the battery from the machine (Fig. A, C)
1. Push the battery unlock button (3).
2. Pull the battery out of the machine like shown
in Fig. C.
Assembling the tubes (Fig. B)
Always remove the battery before mounting
an accessory.
• Slide the upper tube (4) onto the motor housing
until it clicks into place.
• Slide the lower tube (5) onto the upper tube (4)
until it clicks into place.
4. OPERATION
Switching the machine on (Fig. A)
To switch on the leaf blower, press the On/Off
switch (1) to position 1 or 2. Position 1: Blowing
light materials. Position 2: Blowing heavy materials.
To switch off, push the On/Off switch 1 to the stop
in position "0".
EN
7