Set The Basic Settings - JVC KD-T915BTS Manuel D'instructions

Masquer les pouces Voir aussi pour KD-T915BTS:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Getting Started
9
Press
to exit.
To return to the previous setting item, press
3

Set the basic settings

1
Press and hold
.
2
Turn the volume knob to select an item (see the following table), then
press the knob.
3
Repeat step 2 until the desired item is selected or activated.
4
Press
to exit.
To return to the previous setting item, press
[SYSTEM]
[KEY BEEP]
(Not applicable when 3-way crossover is selected.) (Page 30)
[ON]: Activates the keypress tone. ; [OFF]: Deactivates.
[SOURCE SELECT]
[AM SRC]*
[ON]: Enables AM in source selection. ; [OFF]: Disables. (Page 7)
[PANDORA SRC]*
(Except for KD-T711BT)
[ON]: Enables PANDORA FRONT/PANDORA REAR/PANDORA/
PANDORA BT in source selection. ; [OFF]: Disables. (Page 12)
[SPOTIFY SRC]*
[ON]: Enables SPOTIFY FRONT/SPOTIFY REAR/SPOTIFY/SPOTIFY BT in
source selection. ; [OFF]: Disables. (Page 14)
[BT AUDIO SRC]*
[ON]: Enables BT AUDIO in source selection. ; [OFF]: Disables.
(Page 26)
[BUILT-IN AUX]*
[ON]: Enables AUX in source selection. ; [OFF]: Disables. (Page 12)
* Not displayed when the corresponding source is selected.
6
ENGLISH
[USER S.REMO]
.
[F/W UPDATE]
[UPDATE SYSTEM]
[FACTORY RESET]
.
[CLOCK]
Default: [XX]
[TIME SYNC]
[CLOCK DISPLAY]
[ENGLISH]
[ESPANOL]
[FRANCAIS]
[DEMO MODE]
(For KD-T711BT)
See page 36 for details.
[F/W UP xxxx]
[YES]: Starts upgrading the firmware. ; [NO]: Cancels (upgrading is not
activated).
For details on how to update the firmware, visit
<http://www.jvc.net/cs/car/>.
[YES]: Resets the settings to default (except the stored station). ;
[NO]: Cancels.
[ON]: The clock time is automatically set using the Clock Time (CT) data
in FM Radio Broadcast Data System signal/FM Radio Data System signal. ;
[OFF]: Cancels.
[ON]: The clock time is shown on the display even when the unit is turned
off. ; [OFF]: Cancels.
Select the display language for menu and music information if applicable.
By default, [ENGLISH] is selected.
[ON]: Activates the display demonstration automatically if no operation is
done for about 15 seconds. ; [OFF]: Deactivates.

Publicité

Table des Matières
loading

Table des Matières