Cleaning The Pre-Filter - Qlima A 45 Manuel D'utilisation

CLEANING THE PRE-FILTER

The pre-filter must be checked weekly for dirt and if necessary be cleaned.
1. Unplug the device from the wall socket.
2. Remove the back panel. (See chapter on Installation)
3. Remove the pre-filters (4x). They can be easily separated from the filter package.
4. Clean the pre-filters with a vacuum cleaner, brush or a soft, damp cloth.
5. If they are badly fouled then the filters can be rinsed in lukewarm water.
6. Replace the pre-filters on the filter package and replace the back panel.
7. The air cleaner is now ready for use again.
IONISER
This air cleaner is equiped with an ioniser, which starts automatically when the air cleaner
is switched on. The ioniser cannot be switched off.
CLEANING
Switch off the air purifier and remove the plug from the socket before cleaning.
THE EXTERIOR
Clean the exterior with a soft, dry cloth.
If the device is extremely dirty, use a mild cleaning agent.
Wipe the device with a slightly damp cloth.
Never spray the device with water.
STORAGE
If the machine will not be used for a long period of time, take the following steps:
1. Switch off the device.
2. Remove the plug from the socket.
3. Clean the machine.
4. Remove the filter package. Remove the batteries from the remote control.
6. Store the device in a dust free room, preferably covered.
4
61 61