Technical Data - Marmitek LW11G Guide Utilisateur

late the radio signals to the Marmitek X-10 signal on the power line. Using several
remotes and sensors, you only need one central transceiver.
Am I able to increase the range of my remotes by using more Transceivers?
Yes, you can use more than one TM13 Transceiver in your home when the range of your
remotes is not sufficient. The TM13 is using so called collision detection to prevent sig-
nals to be disturbed when more than one TM13 is transmitting. TM13's will wait for a
quite power line before transmitting their data. To prevent your Marmitek X-10 System
to become slow or to prevent dimming from becoming less smooth, make sure that the
TM13 units are placed as far away from each other as possible.
Do you still have questions? Please check out www.marmitek.com for more
information.

TECHNICAL DATA

Power supply:
Power consumption:
Wiring required:
Switching power:
Dimming speed:
Signal sensitivity:
X-10 transmission:
Input impedance:
X-10 key codes:
Additional switch to be connected:
Fuse:
Connectors:
Minimum installation depth:
Ambient temperature:
LW11
™
230 VAC, 50 Hz
< 20 mA, capacitive
Phase and Neutral
60 to 500 W for light bulbs and halogen lighting
Low-voltage halogen light compatible with most
halogen light transformers
Soft start and soft dim. Memory function for
most recent dim setting
3.7 s +/– 0.2 s from 100% to 0%
Can be set to the required dim setting from 0%
15 mVpp min, > 50 mVpp at 120 kHz
1 pulse burst at 0°, 60° and 120°
> 60 ohms (L–N) at f = 120 kHz
All Units Off, All Lights On, On, Off, Dim, Bright,
All Lights Off, Extended Code
momentary switch (must not include a built-in
serial control light)
Can be used for alternating circuits
2.5 A (T) 5 x 20 mm
Screw connectors for Phase, Neutral, switched
Phase and momentary switch
35 mm
-10°C to +50°C (operation)
-20°C to +70°C (storage)
7