Electrical Connection And Mounting - Hennlich ICon-TD7000 Série Instructions D'utilisation

Régulateur de température à affichage digital
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Voltage:
Before connecting the device to the
power supply, make sure that the line
voltage and the voltage of the device
are the same.
Note:
It is absolutely necessary to oper-
ate the controller with a current
circuit breaker (ELCB or RCD)

Electrical Connection and Mounting

After removing the PLEXIGLAS
device can be fixed vertically or horizon-
tally with four screws.
The electrical connection can be con-
ducted as shown in the following picture
Sensor-
Input
®
lid, the
mains entry / protective earth /
controller output (load)
Note:
If there is any doubt about use and
operation,
contact
of TTC (Tyco Thermal Controls) – ISO-
PAD products or manufacturer directly.
– see contact data on rear page.
(direct connection of heater):
(input/output via M-glands:
M12:
1x entry sensor / 1x Alarm out
M16:
1x entry mains supply /
1x load outlet (heater) )
nearest
supplier
Alarm-
output
7

Publicité

Table des Matières
loading

Table des Matières