General; Additional Safety Instructions - Hennlich ICon-TD7000 Série Instructions D'utilisation

General

The ISOPAD digital temperature con-
troller Series ICon-TD7000 is an elec-
tronically working two-position discon-
tinuous temperature controller devel-
oped for controlling of electric heat
devices for usage in industrial and
commercial application
microprocessor technology with a
digital displaying of data.
Precise temperature controlling is
realised through
By use of a hybrid relay and micro-
processor technique,
device reduces overshoots of tem-
perature to a minimum.
Conditions and failures are shown
within the display. In case of failures

Additional Safety Instructions

The device meets the latest European
standards and regulations.
It is absolutely necessary to observe the
following rules:
To open the device:
The device must not be connected to
mains, before opening the case or re-
moving parts with tools. Open PLEXI-
®
GLAS lid by unscrewing all 4 screws,
then lift lid and remove it afterwards.
Malfunction and Excessive
Strain:
If it has been assumed that safe opera-
tion is no longer possible, the installa-
tion must be permanently shut down
and secured against being inadvertently
put back into operation!
6
based on
PID-feedback.
this starting
on the sensor the heating is
switched off. Additional units can
be de-/activated via the alarm out-
put, ie. optical or acoustical signal
units.
The digital temperature controller
Series ICon-TD7000 is mounted
within a MAKROLON
protective system with IP-rating
IP65 (only with positioned and
closed PLEXIGLAS
M-connection glands.
It is not water-proof.
This is the case, if...
...the device shows visible signs
•
of damages
...the device is not operating accord-
•
ing to specification
...the device
•
(no visible indication of reason).
...after excessive strain of any kind,
•
the admissible limits are exceeded
(e.g. storage, transportation, operat-
ing temperature).
Earthing:
The earth protection of the heating cir-
cuit is connected to the terminal board
of the controller. This point is connected
to the earth protection of the consumer.
Therefore the controller must not be
connected without earth protection.
®
case with a
®
lid) and
is not operating