Delta Q QOSY Mode D'emploi page 100

Fig. 19: Programming the coffee
extraction button.
Programming the coffee
Fig. 20:
temperature
.
Programming the coffee extraction button.
Note: The pre-defined factory volume for the coffee extraction button is
around 45cc.
• To alter the volume of your short drink, ensure the machine is ON (see Fig. 6),
check whether there is any water in the water tank and wait until the control
panel buttons indicate "Ready to use" (see Fig. 8).
• Then press the coffee extraction button for 3 seconds.
The luminous indicator of the Standby button changes from green to
orange and the luminous indicators of the espresso coffee and tea
extraction buttons go off. Press the coffee extraction button again which
starts flashing and sets extraction in motion (see Fig. 19).
• As soon as extraction has reached the desired dosage, press the coffee
extraction button again and the operation is complete.
The equipment memorises this volume and will start extracting it until new
programming has been defined.
• After completing extraction, the equipment returns to "Ready to use" mode
(see Fig. 8).
Note: If the user fails to press the extraction button to complete the operation,
the equipment will automatically assume the maximum volume of 65cc.
Programming the coffee temperature
Note: The factory default temperature is a "medium" temperature.
To change the coffee temperature, press the three extraction buttons
(B, C and D) at the same time, and for at least 3 seconds.
The light indicators of the Standby button and long coffee button switch to
orange (see Fig. 20).
QOSY
99