Operation; Maintenance - Franklin Electric INLINE FLOW Manuel D'utilisation

OPERATION

Control Panel
Green LED on
Yellow LED on
Button
Startup
Once the power is turned back on to the device, the green "Power On"
LED should be illuminated.
1. Open a service point or tap in the system.
2. The pump should start and the yellow "Pump On" LED
should be illuminated.
3. The pump will run for several seconds to start the system.
You should begin to see water flowing from the faucet.
a. If more time is needed to see water flowing from the
faucet, press and hold the "Restart" button until water
flows from the faucet.
4. Close the service point and the pump will shut off in a few
seconds. The yellow "Pump On" LED should now be off. If the
pump does not shut off, refer to the Troubleshooting section.
5. Your device is ready to control your pump every time you use
water in the building.
Hazardous Pressure
W A R N I N G W A R N I N G
Booster pumps can produce significant water
pressure within a plumbing system. This
could cause damage to pipes and/or fixtures.
To prevent personal or property damage,
install a pressure relief valve capable of
conveying the entire water volume to a
drain. Maximum system working pressure
is not to exceed 174 psi (400 ft of head).
Anti Pump-Lockup Start
If for any reason the pump remains idle for 24 consecutive hours,
the device will carry out an autorun feature to keep the system free
of debris and clogs. The pump/motor will run for approximately
5 seconds during this test.
8
Power On Device energized
Pump On Pump running
Restart Reset after failure
W A R N I N G

MAINTENANCE

This device is maintenance-free. In case of system maintenance,
review and understand the following safety warnings and product
instructions prior to performing any service.
Hazardous voltage.
W A R N I N G W A R N I N G
Can shock, burn, or cause death.
Ground the device before connecting to
power supply. Disconnect power before
working on the device, pump, or motor.
Hazardous pressure.
W A R N I N G
Relieve system pressure before
disassembling the device.
s
WARNING
!
pump, be sure the fuse box leads are disconnected or the
power is turned off. After reassembling the pump, refer to
these instructions before running.
s
WARNING
!
or cause death. Disconnect power to pump before servicing uni
Draining
s
NOTICE
!
Disconnecting the pump will not
necessarily drain all other parts of the piping system. If there are
any concerns with the proper procedure or necessity of draining
the suction plumbing, contact a water systems professional.
All piping and water tanks exposed to freezing weather should be
drained. If there are any concerns with the proper procedure to
drain the system's pressure tank, contact the tank manufacturer
for assistance.
Before disconnecting the
Hazardous voltage can shock, burn,
t.