Getting Started; Description - Franklin Electric INLINE FLOW Manuel D'utilisation

GETTING STARTED

This owner's manual provides you with the information required
to safely own and operate your flow control switch. Retain these
instructions for future reference.
This flow control switch is of the highest quality workmanship and
material. It has been engineered to give you long and reliable service.
Our products are carefully tested, inspected, and packaged, ensuring
safe delivery and operation.
Inspect Your Shipment
Please examine your product carefully to ensure that no damage
occurred during shipment. If damage is evident, please contact the
place of purchase or report this immediately to your shipping carrier.
They will assist you in replacement or repair, if required. In the case
of shipping damage, the carrier is fully responsible for the product's
safe arrival. Any claim for damage to the shipment, either visible or
concealed, must be made through the shipping carrier.
Package Includes:
• Pump control device
• Booster pump (in certain models)
• Installation manual
s
DANGER
!
Do not use to pump flammable or
explosive fluids such as gasoline, fuel, oil, kerosene, etc. Do not use
in explosive atmospheres. Pump should only be used with liquids
compatible with pump component materials.
Hazardous Pressure
W A R N I N G W A R N I N G
Booster pumps can produce significant
water pressure within a plumbing system.
This could cause damage to pipes and/or
fixtures. To prevent personal or property
damage, install a pressure relief valve
capable of conveying the entire water
volume to a drain. Relieve system pressure
before disassembling the device.
4

DESCRIPTION

This device activates your pump as water is used in the building.
Once the flow stops, the pump turns off. This will protect your pump
in case of a water shortage or dry run event. This product uses either
115 volts or 230 volts and can be installed on any surface-mounted
pump. When using this device, a pressure tank is not required, but
can be used as an optional accessory.
OUT TO SYSTEM
P1+P2
IN FROM MAIN WATER SUPPLY
P1
FLOW
Incoming Main Pressure (e.g. City Main)
Gravity Flow System (e.g. Cistern)
P2
Figure 1
MIN. 8" (20 cm)
FLOW
Figure 2