Fold Down Procedure; Erection Procedure - Upright X Série Guide De L'opérateur

Operation
F D
O L D
This procedure applies only to the X32N model for the purpose of passing through a standard double door-
way. Guardrails must be returned to proper position before using the machine.
F D
OLD OWN
1. Unhook the controller from the side guardrail and place it on the floor of the platform.
2. Pull the retaining pin on the front guardrail and rotate inwards.
3. Pull the retaining pin on the rear guardrail and rotate inwards.
4. Starting with the slide-out deck guardrails and then the outer guardrails, lift up on each guardrail and fold
inward.
E
RECTION
1. Starting with the outer guardrails and then the slide-out deck guardrails, raise each guardrail and drop it
down, securing it in the vertical position.
2. Rotate the front and rear upper guardrails outward and secure them to the opposite side guardrails,
using the retaining pins.
3. Hang the controller on the side guardrail.
Operation Manual
O W N G U A R D R A I L S
P
ROCEDURE
P
ROCEDURE
, X 32N
060572-025 X Series
Page 11