Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2. Installation and Setup
2.1 Rear Panel View
Note: Inspect the unit before performing installation. Make sure nothing inside the package is damaged. Keep the original packaging for future use.
A
Battery Terminal Blocks with Fast-Acting Fuses
B
DC Breaker:
• Battery over-current protection breaker.
• When servicing internal batteries, place the position of the breaker in the "O" position. This breaker does not interrupt DC power flow
between the UPS and any additional battery packs connected in parallel to the UPS. In the event a second battery pack is connected
to the battery bank, the DC voltage from the UPS Bat.+/- will flow through without any interruption to the second battery bank.
Note: The DC breaker is tripped (set to off, or the "O" position) at the factory. Do not flip the breaker's actuator level to the on ("I") position until the
battery pack has been successfully installed and properly connected to the UPS.
C
Input/Output Terminal Blocks: Connects to UPS and additional external battery cabinets.
D
Ground Terminal: Connects to earth ground.
E
Cable Access Ports
2.2 Battery Pack Installation and Setup
Note: To unload unit, removing the batteries may be required.
Unpacking and Inspection
1. Remove the battery pack from the packaging.
Note: The battery pack is extremely heavy. Be cautious when unpacking and lifting the unit to avoid injury.
2. Inspect the package contents for impact or other damage:
• Battery Pack Unit
• Owner's Manual
B
C
D
A
E
4
C
Publicité
Table des Matières
