Krups XP42 Mode D'emploi page 13

IFU_KR_XP4200_NAFTA_NC00026258-01 18/11/11 13:47 Page15
n Insert the filter holder and turn the handle to the right as far as it will go.
You will hear a clicking sound as the Krups Precise Tamp (KPT) system
automatically adjusts the tamping level depending on the amount of
coffee grounds used. The handle will become progressively harder to
turn as you approach the optimum tamping level, do not force the handle
past this point. Use the "one cup" and "two cup" markings on the
brewing head as a guideline of where to stop. Because the Krups
Precise Tamp automatically adjusts the tamping level, you may find that
you do not always stop at the same point each time. Never turn the
handle past the far right edge of the "one cup"marking (fig.7).
n Put one or two cups under the filter holder as desired.
As soon as the required temperature is achieved, the light will stop
flashing.
n Turn the dial to the
n When the cups are filled with the desired amount of espresso, turn
the dial back to the
n Unlock the filter holder by pressing the
turning the handle to the left to release, and remove the filter holder
from the machine.
n Remove the used espresso grounds using the ejection system by
holding the filter holder upside down over a trash receptacle. Press
the « PUSH » button located between the two coffee outlet nozzles
on the underside of the filter holder (fig.11). Rinse the filter holder
under running water, pressing « PUSH » while rinsing to release any
remaining grounds. Once the filter holder has been rinsed and dried
it can be refilled to prepare more espresso.
IMPORTANT: Do not store the filter holder in the locked
position when the machine is not in use to avoid
unnecessary wear to the seal.
W I T H A N " E . S . E . " E S P R E S S O P O D
"ESE" for "Easy Serving Espresso" is a packaged pod (44 mm
diameter) of 7g of selected coffee, ground and compacted between
two paper filters, specially designed to make Italian style ristretto
(tight) espressos.
This system allows for simple and clean use of your machine.
n Fill the water tank with fresh cold water to the maximum line and turn
on the machine (fig.1, 2, 3 and 4). The light will flash while the
machine preheats
position (fig.8).
position.
English
button on the handle while
15