Enclosure Preparation - Bosch SRV53C Guide D'entretien Et D'utilisation

90
17-3/4" – 18-1/8" (451–460mm)
Check
clearance
between
dishwasher
door and wall
4
Enclosure Requirements
23-9/16"
(598mm)
90
31-7/8 – 34-1/4"
(810 - 870mm)
Figure 1
Countertop
Figure 2
4-1/2"
(114mm)
2-1/2"
(64mm)
Figure 3
WARNING
Avoid Scalding or Electrical Shock Hazard
Make sure the water supply and electrical supply
are shut off before installation or service.

ENCLOSURE PREPARATION

NOTE: This dishwasher is designed to be enclosed on the
top and both sides by standard residential kitchen
cabinetry.
Select a location as close to the sink as possible for
easy access to water supply and drain lines.
For proper dishwasher operation and appearance, ensure
that the enclosure is square and has the dimensions
shown in Figure 1.
If the dishwasher is to be installed in a corner, make sure
that there is adequate clearance to open the door. See
Figure 2.
WARNING
Avoid Electrical Shock/Fire Hazard
Do not allow the electrical and water supply lines
to touch.
After locating the proper place for your new dishwasher,
you will need to make any required openings to allow for
passage of the water, drain and electrical line. In order to
avoid interference with the dishwasher when sliding it into
the cabinet, place your openings within the dimensions
shown in Figure 3.
Required Openings:
1
4 / " x 2" (108 x 52mm) -
4
3
3" x 1 / " (76 x 45mm) -
4
1 1 / " (32mm) diameter -
4
NOTE: If the incoming electric supply, water supply and
drain connections are all in the same cabinet, the one
1
4 / " x 2" (108 x 52mm) hole will be large enough for all
4
three to pass through.
To pass the included
electrical supply junction box
through to an adjacent
cabinet
To pass the included water
supply line toward the water
supply
To pass the dishwasher drain
hose toward the drain
connection