Silverline 727787 Mode D'emploi page 4

GB
Introduction
Thank you for purchasing this Silverline tool. This manual contains information necessary
for safe and effective operation of this product. This product has unique features and, even if
you are familiar with similar products, it is necessary to read this manual carefully to ensure
you fully understand the instructions. Ensure all users of the tool read and fully understand
this manual.
Description of Symbols
The rating plate on your tool may show symbols. These represent important information about the
product or instructions on its use.
Wear hearing protection.
Wear eye protection.
Wear breathing protection.
Wear head protection.
Wear hand protection.
Read instruction manual.
LASER warning!
Caution!
Conforms to relevant legislation and safety standards.
Environmental Protection
Waste electrical products should not be disposed of with household waste. Please
recycle where facilities exist. Check with your local authority or retailer for recycling
advice.
4
Original Instructions
Technical Abbreviations Key
V
~
A
m
Hz
W, kW, mW
nm
mm
Specification
Maximum measuring range: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.2–40m
Measuring accuracy:...................... . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ± 1.5mm
Measuring units: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Metres
Laser class: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Laser wavelength: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 650nm, ≤1mW
Power supply:. . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 x AAA 1.5V batteries (not included)
Operating temperature: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0°C–40°C
Storage temperature: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .-10°C–60°C
Auto laser off: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 30 seconds
Auto power off:. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .180 seconds
As part of our ongoing product development, specifications of
Silverline products may alter without notice.
Laser Safety
The laser used in this device is a Class 2 laser with maximum power of ≤1mW and a wavelength
of 650nm.
These lasers do not normally present an optical hazard, although staring at the beam may cause
flash blindness.
WARNING: Avoid direct eye contact.
A hazard may exist if you deliberately stare into the beam, please observe all safety rules as follows:
∙ The laser shall be used and maintained in accordance with the manufacturer's instructions
∙ Never aim the beam at any person, and particularly not into the eyes of any person or animal, or
any object other than the workpiece
∙ Always ensure the laser beam is aimed at a sturdy workpiece without reflective surfaces. i.e. wood
or rough-coated surfaces are acceptable. Reflective sheet steel or similar is not suitable for laser use
as the reflective surface could direct the beam back at the operator
∙ Do not change the laser light assembly. Repairs must only be carried out by the laser manufacturer
or an authorised agent. DO NOT exchange with a different type of laser
CAUTION: Use of controls or adjustments or performance of procedures other than those specified
herein may result in hazardous radiation exposure.
Please refer to the relevant EN standards, EN61326-1:2013 for more information on Lasers.
Volts
Alternating current
Ampere
Metres
Hertz
Watt, kilowatt, milliwatt
Nanometres
Millimetres