Repair And Services - URBANGLIDE 55 Manuel D'utilisation

REPLACEMENT OF THE REAR WHEEL
Tools needed: 1 pc screw driver, 1 pc 12--14mm open spanner, and 1 pc 13--15mm open spanner.
Loosen the locking screws
on the motor cover using a
Philips screwdriver and
take off the cover.
REPLACING THE REAR WHEEL
Mount the replacement rear
wheel assembly onto the
frame by inserting the
assembly into the rear wheel
axle housing by reversing the
operation described in step 2
above.

REPAIR AND SERVICES

Loosen the fixing screws using
Philips screwdriver
Take note of the location of the parts on the rear wheel and make
sure all these parts are in their correct position when re-mounted.
Make sure the rear wheel
axle has slid home in the
rear wheel axle housing on
the frame. Then tighten the
motor fixing screws using a
Philips screwdriver.
Remove the rear wheel axle
nut using a 13mm and a
14mm solid spanner.
Tighten the rear wheel axle
nut with a 13mm and a
14mm spanner and then
check that the wheel is able
to rotate freely
Mount the motor cover using
a screwdriver. Do not overs-
tighten the screws or the
motor cover might be
damaged.
7