Publicité
Les langues disponibles
Les langues disponibles
23.1 The adhesive of heat the shrink tube may melt during the shrinking of
the heat-shrinkable cap.
23.2. Pinch again with needle nose pliers as shown.
23.3. Make sure the heat shrink tube is completely sealed between two
insulated bus wires and has no visible gap.
24. Remove release paper from mastic strips, wrap one strip of mastic with
width (not length) around the each heated shrinkable cap against the
end of the 1/2 inch x 1 inch heat-shrinkable tube and position as shown.
(Important: Stretch the mastic strips otherwise the width will not be able to
fully go around each of the heat shrinkable cap).
24.1 Stretch the mastic strips.
Pr tecTHERM Instructions and parts manual
24.2 Wrap one strip of mastic with stretched width.
25. Squeeze the mastic together.
5
Publicité
