Part 6. Maintenance - involight FOG900 Mode D'emploi

Part 6. Maintenance:

Regularly check the technical safety of the fogging machine. To damage the connecting leads and the housing.
Strong dust deposits, fog residues and dirt reduce the performance and can lead to failure of the device due to
overheating. For longer storage, it is recommended to run the machine at least every 1 to 3 months. Longer
periods out of service can lead to a significant reduction in the life of the machine. Damage caused by a lack of
cleaning of the device is not covered by the product warranty.
Cleaning.
Disconnect the unit from the mains and allow it to cool completely before cleaning.
For external cleaning, use only a dry, soft cloth, in no case chemicals or water that could run into the unit. Clean
the ventilation openings with a soft brush, cotton swab, a vacuum cleaner or compressed air. Fog machines are
susceptible to clogging due to the thick liquid mist and high evaporation temperature. For this reason, it is
recommended to run a cleaning liquid consisting of 90% distilled water and 10% vinegar after approx. 60 operating
hours.
Method:
1. Disconnect the fogging machine from the mains and allow it to cool down sufficiently.
2. Fully drain the tank.
3. Place the unit in a well-ventilated place.
4. Fill the tank with the indicated cleaning fluid.
5. Connect the device to the power supply.
6. Wait until the required operating temperature is reached.
7. Operate the unit in a well-ventilated area with the cleaning liquid until the tank is empty.
8. Cleaning is complete. Turn the unit off and wait until it has cooled down completely before refilling the mist fluid.
Change of fuse.
IMPORTANT: Replace the fuse only with a fuse of the same type and with the same values (printed on the unit). If
the fuse is triggered repeatedly, please contact an authorized service center.
Method:
1: Unplug the power cord from the wall outlet.
2: Open the fuse holder on the back of the unit with a suitable screwdriver.
3: Remove the defective fuse from the fuse holder.
4: Insert the new fuse in the fuse holder.
5: Replace the fuse holder in the housing.
Maintenance and service are reserved for the authorized personnel only!
16