Section 4 − Operation; Controls − Front Panel - OXO MVP12-RC Série Manuel Du Propriétaire

4-1. Controls − Front Panel
OM-226 167 Page 14
SECTION 4 − OPERATION
Front Control Panel
1
Use JOG position to momentarily
feed welding wire at speed set on
Wire Speed control without energiz-
ing welding circuit or shielding gas
valve. Use Gas position to momen-
tarily purge gas line without energiz-
ing weld wire.
2
1
Use control to adjust wire speed
within range selected by switch.
3
Use switch to select high or low wire
speed range.
4
2
Use control to adjust slow run-in
speed.
5
Press right side of the switch (turns
on soft start/slow run-in) to feed weld
3
wire into place more slowly than se-
lected wire speed.
6
Press the right side of the switch
(turns trigger hold on) to weld without
holding gun trigger throughout the
weld cycle.
Press and release gun trigger to initi-
4
ate welding. Press and release gun
trigger a second time to stop.
7
Use control to adjust voltage output
of welding power source.
5
6
7
JOG/Gas Switch
Wire Speed Control
HI/LO Range Switch
Soft Start or Slow Run-In
Control
Soft Start or Slow Run-In
Switch
Trigger Hold Switch
Remote Voltage Control
804 073