Installing And Threading Welding Wire - OXO MVP12-RC Série Manuel Du Propriétaire

3-6. Installing And Threading Welding Wire

1
WOOD
2
6 in
(150 mm)
Pull and hold wire; cut off end.
Tighten
Clockwise
3
Hold wire tightly to keep
it from unraveling.
Installing Wire And Adjusting
Hub Tension:
1 Hub Nut
2 Hub Brake Adjusting Knob
Remove hub nut and install spool
so hub pin fits spool hole. Reinstall
hub nut.
Adjust thumb brake knob so only a
slight force is needed to turn spool.
Threading Welding Wire:
3 Pressure Assembly
Adjustment Knob
Lay gun cable out straight.
Open pressure assembly. Hold
wire tightly and cut off end. Push
wire through guides into gun.
Close and tighten pressure assem-
bly. Press Jog switch until wire
comes out gun.
Feed wire against wooden surface,
and tighten knob so wire does not
slip.
Cut off wire, and close door.
Tools Needed:
9/16 in
804 065-A
OM-226 167 Page 13