Installing And Aligning Wire Guide And Drive Rolls - OXO MVP12-RC Série Manuel Du Propriétaire

3-2. Installing And Aligning Wire Guide And Drive Rolls

5
4
3
Aligning Wire Guide And Drive Rolls
Correct
9
8
7
OM-226 167 Page 10
Installing Wire Guide
And Drive Rolls
1
6
2
10
11
Incorrect
Installing Wire Guide And Drive
Rolls:
1 Drive Roll Nut
2 Drive Roll Carrier
Turn nut one click until lobes of nut
line up with lobes of drive roll carrier.
3 Drive Roll
Slide drive roll onto drive roll carrier.
Turn nut one click.
Repeat procedure for top drive roll.
4 Inlet Wire Guide Screw
5 Inlet Wire Guide
Loosen securing screw. Install inlet
guide so inlet guide screw is
centered in groove in guide and tip
is as close to drive rolls as possible
without touching. Tighten screw.
6 Outlet Wire Guide
Install using 1/2 in. socket or driver.
Aligning Wire Guide And Drive
Rolls:
View is from top of drive rolls look-
ing down with pressure assembly
open.
7 Drive Roll Securing Nut
8 Drive Roll
9 Wire Guide
10 Welding Wire
11 Drive Gear
Insert allen wrench and turn screw
in or out until drive roll groove lines
up with the outlet wire guide as
shown.
Close pressure roll assembly.
Top drive roll is self-adjusting.
Cleaning Drive Rolls:
Remove drive rolls, and clean
grooves using a wire brush.
Tools Needed:
804 061-A