Opening Out/Removing The Back Panel Of Media Rack 1 And Sideboard - VS 600 Série Instructions De Montage

(2)
(3)
(1)
8. Opening out /removing the back panel
of media rack 1 and Sideboard
Cables can be fed into the module through the cover top.
The back panel must be opened out for this purpose.
Opening out the back panel. Release back-panel lock (1).
Open out the back panel (extent of opening limited by steel
cable (2)).
Removing the back panel where necessary. Release steel
cable (2) from the back panel by turning knurled nut (3).
Remove the back panel.
14
Refitting the back panel. Position the back panel in the
groove. Twist knurled nut (3) of steel cable (2) back into the
back-panel screw.
Cabling in the body. There are two cable outlets in the
base. Feed the corresponding cables outwards through these
outlets (see "Cabling through the cable outlets").
(3)